Hillary PE wall cloth construction instructions and matters to note
Note:
1. It takes 2-3 days for a non-woven cloth or paper base to be affixed. It will wear out at both ends and decrease in quantity by about 1.5 % to 2 %.
2. Do not accept return after applying the non-woven cloth.
Construction instructions for Silari PE wall cloth
Wall conditions
1. The walls must be flat, clean, dry, free of cracks, empty, moldy, oil free, smooth, straight, and smooth in the yin and Yang horn, with a water content of less than 8 % in the grass. If the above mentioned conditions are not met, the wallpaper is liable to produce such undesirable symptoms as mildew, sloughing and pulling.

2. Human rights PE wall cloth is of high toughness and strong texture. In the treatment of the base wall, need to brush a layer of high hardness of the substrate, the substrate coating requirements uniform can not have pimples. The high hardness of the substrate reduces warping and interface marks due to cutting. It also ensures that the next wallpaper replacement will not damage the wall, but also waterproof, mildew proof, to prevent acid and alkali material in the wall overflow

2. PE Wall Cloths
1. Please carefully check if there is a serious color difference in wallpaper before construction. It is recommended to choose the same type and batch number of wallpaper to reduce the color difference. PE wall cloth color will occasionally have slight inhomogeneity, belongs to the normal range.
2. PE wall cloth need to choose our special special glue, use self-purchased glue need to consult our technical staff 13823786095 Liusheng, otherwise we do not pay the responsibility for the problems. Clean and cut off the back of PE wall cloth, then evenly brush the back of PE wall cloth, thick and thin, and then directly paste. The walls need not be glued. Because PE wall cloth is high in toughness, the texture is more hard to meet the side of the corner, the PE wall cloth can be fitted with the angle after the heat dryer. When using hot hair dryer, the PE wall cloth can not accept over 70 ℃ high temperature.

3. Draw a vertical line from the ceiling to the floor, using this line as the side line for the first piece of wallpaper. After the wallpaper, use the scraper to gently scrape the wall cloth, the crease and excess glue out, so that the wallpaper flat against the wall, PE wall cloth will not produce bubbles. All do not need to scrape, squeeze, there is glue scraping seams will not pollute the surface. Just clean it up.
4. Do not cut the wall paper according to the wall height 5 cm to 8 cm length, as the upper and lower edge for use, and suggest the positive and negative construction so that the colors uniform, avoid light refraction wallpaper color.
5. The pattern symmetry shall be taken into account for wall paper, and the length of the cut shall be increased as appropriate according to the length of the unit in which the pattern is repeated. Generally 2-5 cm on the sides, after the pattern alignment before cutting, PE wall cloth because of the special texture, in order to make the wallpaper edge does not cause obvious seam, please use a sharp blade.

3. Cleaning methods:
PE wall cloth can use a feather duster dust, then choose clean wet towel or sponge scrub.
Note:
Before construction, please read the construction guide and the product construction instructions on the back of the product trademark paper.
2. Before and during the construction process(after 3 to 4 general frames), the quality problems(such as shade of chromatism or other undesirable conditions) should be carefully checked, and the construction should be stopped as soon as possible(to avoid waste loss) and the suppliers should be contacted.
3. During construction, it is recommended to choose or take measures to maintain indoor temperature at 10-30 ℃. Please close doors and windows and do not use air conditioning, electric fans and other ventilation equipment until the wallpaper is completely dry.
After construction, we should keep the wallpaper dry for 5 days or so, and pay more attention to it during the winter heating period, so as to avoid cracking because the wallpaper is drying too fast